Mateksys F405-WING Flight Controller

FC Specificaties

• MCU: 168MHz STM32F405
• IMU: MPU6000 accelerometer/gyro (SPI)
• Baro: BMP280 (I2C) of DPS310
• OSD: INAV OSD w/ AT7456E chip
• Blackbox: MicroSD card slot (SD/SDHC)
• VCP & 6x UARTs
• 2x Motors, 7x Servos outputs
• 2x I2C
• 3x LEDs for FC STATUS (Blauw, Rood) and 3.3V indicator (Rood)
• Ingebouwde omvormer voor SBUS input (UART2-RX)
• PPM/UART Shared: UART2-RX
• SoftSerial on TX2 pad
• Battery Voltage Sensor: 1:10 (Scale 1100)
• WS2812 Led Strip : Ja
• Beeper: Ja
• RSSI: Ja

FC Firmware

• INAV Flight Target: MATEKF405SE
• ArduPilot hwdef: MATEKF405WING

PDB

• Input voltage range: 9~30V (3~6S LiPo) w/TVS beveiliging
• 2x ESC power pads
• Current Senor: 104A, 3.3V ADC, Scale 317
• Sense resistor: 60A continuous, 104A Peak

BEC 5V output

• Geschikt voor Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
• Continuous current: 2 Amps, Max.3A

BEC 9V /12V output

• Geschikt voor videozender, camera, gimbal etc.
• Continuous Current: 2 Amps, Max.3A
• 12V option met Jumper pad

BEC Vx output

• Designed for Servos
• Voltage aanpasbaar, 5V Default, 6V of 7.2V via jumper
• Continuous current: 5 Amps, Max.6A
• Output Ripple: 50mV (VIn=24V, VOut=5V@5A load)

BEC 3.3V output

• Geschikt voor Baro / Compass module en Spektrum RX
• Linear Regulator
• Continuous current: 500mA

Afmetingen

• Montagepatroon: 30.5 x 30.5mm
• Afmetingen: 56 x 36 x 13 mm